Support for MillMax Users

Unlocking the VP-Harmonizer, Harmonizer Recommends a Very High Speed, Saving a VP-Harmonizer File, I am getting a VP Harmonizer Error Contact MLI for support. Error code -100, Where is the the Harm...

ERROR MESSAGE: This data file is not licensed to display the Dynamic Cutting Calculator, ERROR MESSAGE: All channels were out of range, you may have a bad DAQ card, ERROR MESSAGE: Hardware Lock Er...

Using Verify Dongle, Why are files automatically saved?, Ray Gavin's Setup Spreadsheet, Which Hammer Tip Should I Use?, Converting MillMax from Inch to Metric, Switching MillMax for Left Handed Use...

How do I tune the stick length of an endmill?, What about workholding or the workpiece?, Tap-Testing a thin wall part, How do I track spindle condition?, Calculating Feed Rate for Circular Interpol...

How long has tap-testing been around?, What about drilling, boring and turning?, Dashboards vs. Okuma NAVI, What is BlueSwarf?

Why isn't this wireless?, Do you have to tap-test after every tool change?, What is the best toolholder?, Does chatter affect accuracy?, When I change the feed rate the stable speeds do not change,...

Tap Testing Live Tooling , Tap-Testing Feed Mills, Tap Testing Thread Mills, Tap-testing unconventional cutters, like dovetail or angle mills., Tap-Testing Barrel Cutters, Tap-Testing a Keyseat Cut...

Customer's current tool is stable but the tap-test and Dashboard say it is in the red., The graph on the MillMax home page is blank, Practice keeps saying Hit Harder, The buttons on MillMax screen ...

Is there a difference between conventional and climb milling when it come to its dynamics?, Calculating Endmill Stickout without Measuring, Do chipbreakers make a difference in tap-testing?, Materi...

Articulate Settings for Training, Opening old Flash-Based Dashboards, Installing drivers for old black box kits., Surface GO Tablet is stuck., How to change name of incoming support folder, Federal...

The Dashboard does not go to zero, Dashboard issues with a Negative Rake Milling Cutter, Why are there two files with the same name in the Dashboard folder?, Does the Dashboard care if the coolant ...

Boeing Milling Seminar, Proper handling of the accelerometer, Positioning and Mounting of the Accelerometer, How to use the hammer, Anatomy of the Double Hit, Tapping Direction, Explaining Flexibil...

Minimum data required to produce Dashboard, Fast Entry in MillMax, New Features - May 2022, New Features - May 2021, Mini-Hammer Trigger Adapter, Large Hammer and Accelerometer Add-On, Acceleromete...

Installing or Updating Sensor File, Manually Updating Dongle, Default Material Database, Default Setup Files

What is the repeatability of the Z-offset on ST endmills?